Shorting Adapters for Calibrating Coupling Decoupling Networks

Before you begin testing with the CDNs you will need to establish calibrated drive levels corresponding to your desired test levels. During drive level calibration, the RF signal level being injected to the Coupling Decoupling Network is adjusted incrementally until the voltage level measured at the 150Ω to 50Ω adapter (ADA-515-2) connected to the EUT port of the CDN is approximately equal to the Umr value given in the table below. The ADA-515-2 and accessories needed for this test are available via Shieldingshop as well.

Test Levels
Open Circuit Voltage
     Umr      
1 0.167
3 0.5
10 1.67

Umr = Voltage level measured at the output of the 150Ω to 50Ω adapter (ADA-515-2)

Shorting Adapters for Calibrating Coupling Decoupling Networks
Read more
Com-Power Shorting adapters for CDN (Screened Series)

Shorting adapters for CDN (Screened Series)

Shorting adapters for Coupling Decoupling Networks part of the Screened Series.

€65,00

Information
Com-Power Shorting adapters for CDN (Telecom Series)

Shorting adapters for CDN (Telecom Series)

Shorting adapters for Coupling Decoupling Networks that are part of the Telecom Series.

€65,00

Information
Com-Power Shorting adapters CDN (M-Series)

Shorting adapters CDN (M-Series)

Shorting adapters for CDN M-Series

€65,00

Information
Com-Power 150 Ohm to 50 Ohm adapter

150 Ohm to 50 Ohm adapter

The 150Ω to 50Ω adapter pair is used for calibration of Coupling Decoupling Networks (CDN).

€375,00

Information
Com-Power 50 Ohm Terminator (TEP-050)

50 Ohm Terminator (TEP-050)

50 Ohm Terminator for Calibrating Coupling Decoupling Networks.

€175,00

Information
Com-Power Shorting adapters for CDN (Audio Frequency Series)

Shorting adapters for CDN (Audio Frequency Series)

Shorting adapters for Coupling Decoupling Networks that are part of the Audio Frequency Series.

€65,00

Information
Excl. tax